Tick the mods that you want. The page checks which ones combine and builds one file. It also
shows the command that builds the same file from the repository. Three mods take your own files:
audio for the transients, wavetables for the LFO waves and a picture for the boot screen. When
you tick one of them, its files open below it. Each mod's own page is its manual.
Make sure that you can go back to stock before you flash a modified file.
The Early Start-up Menu flashes the stock firmware over MIDI. Do this one time with the stock
file, before you flash a modified file. Back up your +Drive.
Go to 1.11 from 1.10E. If your unit has OS 1.10D, install the stock OS 1.10E
first. Then install OS 1.11, stock or modified. Do not go from 1.10D directly to 1.11.
We did not make these mods to work with mods from other developers. Some of
our mods keep their settings in parts of a project that stock firmware does not use. A mod from
another developer can keep its data in the same parts. If you open a project made with another
developer's mods and then save it, the save can delete or change that developer's data. Before you do
this, keep a copy of the project.
1. Your firmware
An unmodified Digitone II OS 1.11 .syx from Elektron.
or drag it here
2. Mods
A mod that does not combine with one you ticked is greyed out, with the reason.
SETTINGS > SYSTEM > MODS lists the mods of your build and their versions on the instrument.
Mods that are still in progress are not here. The home page lists them under
In progress.
Your transients: 0 of 32 slots replaced
Choose a slot, then drop audio on it or choose a file. You can use any format and rate that
your browser can play. The page mixes the audio to mono, resamples it to 48 kHz and fits it
to the length of the slot. Click the waveform to hear it.
Off (the default): each slot keeps its factory length: 50, 100 or
150 ms. Choose a slot that is long enough for your sample. The factory transients that you
do not replace sound exactly as before.
On: every slot is 107.6 ms, 5,164 samples. Every sample gets the same
space. But the build changes the factory transients that you do not replace. It cuts the 8 of
150 ms to 107.6 ms, with a short fade. It pads the other 24 with silence: the 3 of
50 ms, and the 21 of 100 ms by 7.6 ms each. The slots below mark them.
You can change this before you build. The page fits your samples again to the new lengths.
yoursfactorycut or pad: a factory slot that equal slots changeEach slot shows its number, its TRAN value (4 × slot), a bar for its length and the
length in ms.
POS sweeps a table of 7 frames, blended. Keep ours, or drop your own on a table:
a WAV wavetable as most wavetable editors export it, a single-cycle WAV or a JSON table. The page
reduces any table to 7 frames of 32 points.
The table shows every pair of mods, tried in both orders on stock 1.11.
dnfw mods matrix generates it. The page reads it to grey out the mods that do not
combine. ✓: the two mods combine in either order. ✓*: they combine in one order only,
and the page uses that order. ✗: they cannot combine. To see the reason, put the pointer on
a cell. Some mods in the table are not on this page yet.